![]() ![]() I just used a zip tie to keep them connected. The wire bundles still connect together just fine, just the safety clips that hold the connections together can't be used. The only issue I ran into is that the wire connections on the new board had the opposite clips as the old board. Installation is the reverse order of removal. When mine arrived I gave it a healthy coat of conformal coating which is used to waterproof electronics, figured it would help prolong the life of the new board if any moisture got up in there again. ![]() They are also available on Amazon and eBay for around $30. Go to greenworks website and order the new board, mine was $12.50 plus $8 shipping. There should be a part number on the side of the PCB, mine was 362011505B my PCB board had several burnt or rusted circuits. Remove the battery holder from inside the black cowl, should be about 10 more small star drive screws. ![]() Take off the black cowl from the top should be about 10 small star drive screws.ĭisconnect the 4 wire connectors that connect the PCB to the motor and such. ![]() Remove the battery holder from inside the black cowl, should be about 10 more small. Disconnect the 4 wire connectors that connect the PCB to the motor and such. Take off the black cowl from the top should be about 10 small star drive screws. Same symptoms, runs half a second to 5 seconds stops and beeps. Same symptoms, runs half a second to 5 seconds stops and beeps. I have the 80V mower too.literally just fixed it this morning. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |